Iptables -I FORWARD -i br0 -o tun0 -j ACCEPT # Thus, we include them so that this works for more people: # I (dereks) did not need them, but bmatthewshea did. # These next two lines may or may not be necessary. Iptables -I INPUT 1 -p udp -dport 1194 -j ACCEPT # port must be 5001 for scripts embedded in firmware to work # management parameter allows DD-WRT\s OpenVPN Status web page to access the server\s management port # Only use crl-verify if you are using the revoke list - otherwise leave it commented out (which I was able to do under the same setup when the dd-wrt device was my DHCP server) My goal is to access my NAS and other devices on the LAN. However I CAN access a web server on my network (by LAN IP address) that has a port forwarding rule on the RV320 that enables WAN access. However, I cannot access the RV320 web gui. So the dd-wrt device is setup in router mode, with WAN connection disabled and DHCP disabled. It's behind a cisco RV320 with the OpenVPN port opened. OpenVPN is configured in Web GUI to start at System and run as Daemon. I'm trying to setup the OpenVPN server on:ĭD-WRT v24-sp2 (12/22/14) giga - build 25697 Posted: Fri 5:14 Post subject: OpenVPN server on AP in router mode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |